Dell XPS 600 - Manual (Page 36)

Removing and Installing Parts: Dell XPS 600 Service Manual
parts0.htm[4/10/2014 9:50:52 PM]
The tops of all cards and filler brackets are flush with the alignment bar.
The notch in the top of the card or filler bracket fits around the alignment guide.
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer
cover from closing properly or cause damage to the equipment.
6. Press the retention arm into place, securing the card(s) in the computer.
1 filler bracket
2 alignment guide
3 alignment bar
4 retention arm
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug the cable into
the computer.
7. Replace the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
8. If you removed a sound card or a network adapter, see " Network Adapter and Sound Card Settings ."
9. Uninstall the driver for the card that you removed.
Installing PCI and PCI Express Cards
NOTICE: If you have or are upgrading to the optional dual-graphics configuration, see " Installing PCI Express Graphics
Cards in a Dual Configuration " to install a graphics card.
1. Follow the procedures in " Before You Begin ."
2. Press the lever on the card retention arm and raise the retention arm.