Dell PowerEdge 2650 - Manual (Page 27)

Warning Messages
A warning message alerts you to a possible problem and asks you to take corrective action before the system continues a task. For example, before you
format a diskette, a message may warn you that you may lose all data on the diskette. Warning messages usually interrupt the procedure and require you to
respond by typing y (yes) or n (no).
Diagnostics Messages
When you run a test group or subtest in system diagnostics, an error message may result. Diagnostic error messages are not covered in this section. Record
the message on a copy of the Diagnostics Checklist (see "
Getting Help "), and then follow the instructions in that section for obtaining technical assistance.
Alert Messages
The optional systems management software generates alert messages for your system. For example, the software generates messages that appear in the
SNMP trap log file. Alert messages consist of information, status, warning, and failure messages for drive, temperature, fan, and power conditions. For more
information, see the systems management software documentation.
Back to Contents Page
4-4-1 Super I/O chip failure; faulty system
board. See " Getting Help ."
4-4-2 BIOS-shadowing failure. See " Troubleshooting System Memory " in "Troubleshooting Your System."
4-4-3 Microprocessor speed control sequence
failure. See " Troubleshooting a Microprocessor " in "Troubleshooting Your System."
4-4-4 Cache test failure; faulty microprocessor.
NOTE: For the full name of an abbreviation or acronym used in this table, see " Abbreviations and Acronyms ."
NOTE: Warning messages are generated by either the application program or the operating system. For more information, see " Finding Software
Solutions " and the documentation that accompanied the operating system or application program.