Dell PowerEdge 2650 - Manual (Page 54)

2. Remove the cover (see " Removing the Cover " in "Troubleshooting Your System").
3. Locate the memory module connectors in which you will install a memory module (see Figure A -3 ).
4. Press down and outward on the memory module connector ejectors, as shown in Figure 6 -5 , to allow the memory module to be inserted into the
connector.
Figure 6-5. Removing and Installing a Memory Module
5. Align the memory module's edge connector with the alignment key, and insert the memory module in the connector (see Figure 6 -5 ).
The memory module connector has an alignment key that allows the memory module to be installed in the connector in only one way.
6. Press down on the memory module with your thumbs while pulling up on the ejectors with your index fingers to lock the memory module into the
connector (see Figure 6 -5 ).
When the memory module is properly seated in the connector, the memory module connector ejectors should align with the ejectors on the other
connectors with memory modules installed.
7. Repeat steps 3 through 6 of this procedure to install the remaining memory modules.
8. Perform steps 4 through 8 of the procedure in " Performing a Memory Upgrade ."
Removing Memory Modules
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the cover (see " Removing the Cover " in "Troubleshooting Your System").
3. Locate the memory module connectors from which you will remove memory modules (see Figure A -3 ).
4. Press down and outward on the memory module connector ejectors until the memory module pops out of the connector (see Figure 6 -5 ).
5. Repeat steps 3 and 4 of this procedure to remove any other memory modules.
6. Perform steps 4 through 8 of the procedure in " Performing a Memory Upgrade ."
System Board Tray
See Figure A -3 to identify the system board components.
Removing the System Board Tray
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the cover (see " Removing the Cover " in "Troubleshooting Your System").
3. Rotate the system board tray levers up simultaneously until the tray releases from the chassis (see Figure 6 -6 ).
Figure 6-6. Removing and Installing the System Board Tray
CAUTION: Before you perform this procedure, you must turn off the system and disconnect it from its power source. For more information, see
" Safety First—For You and Your System " in "Troubleshooting Your System."
NOTICE: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System Information document.
CAUTION: Before you perform this procedure, you must turn off the system and disconnect it from its power source. For more information, see
" Safety First—For You and Your System " in "Troubleshooting Your System."
NOTICE: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System Information document.