beautypg.com

Dell Precision 620 User Manual

Page 101

background image

terminated by
keystroke

No boot device
available

The computer cannot find the diskette or hard-disk
drive.

Enter

System Setup

, check the system configuration

information for the diskette and hard-disk drive, and if
necessary, correct the information.

No boot sector on
hard-disk drive

The system configuration information in System Setup
may be incorrect, or the operating system may be
corrupted.

Enter

System Setup

, check the system configuration

information for the hard-disk drive, and if necessary,
correct the information.

If the message persists, reinstall your operating system.
See the documentation that came with your operating
system.

No timer tick
interrupt

A chip on the system board might be malfunctioning.

Run the System Board Devices tests in the

Dell

Diagnostics

.

Non-system disk or
disk error

The diskette in drive A or your hard-disk drive does not
have a bootable operating system installed on it.

Either replace the diskette with one that has a bootable
operating system, or remove the diskette from drive A
and restart the computer.

Not a boot diskette

There is no operating system on the diskette.

Boot the computer with a diskette that contains an
operating system.

Plug and Play
Configuration Error

The system has encountered a problem in trying to
configure one or more expansion cards.

Turn your system off and unplug it. Remove all but one
of the cards. Plug in your system and reboot it. If the
message persists, the expansion card may be
malfunctioning. If the message does not appear, turn off
the power and reinsert one of the other cards. Repeat
this process until you identify the malfunctioning card.

Read fault

The operating system cannot read from the diskette or
hard-disk drive.

See "

Troubleshooting Drives

."

Requested sector not
found

The system could not find a particular sector on the
disk, or the requested sector is defective.

See "

Troubleshooting Drives

."

Reset failed

The disk reset operation failed.

See "

Troubleshooting Drives

."

Sector not found

The operating system is unable to locate a sector on
the diskette or hard-disk drive.

See "

Troubleshooting Drives

."

Seek error

The operating system is unable to find a specific track
on the diskette or hard-disk drive.

If the error is on the diskette drive, try another diskette
in the drive.

Shutdown failure

A chip on the system board might be malfunctioning.

Run the System Board Devices tests in the

Dell

Diagnostics

.

Time-of-day clock
stopped

The battery may be dead.

Enter

System Setup

and correct the date or time.


If the problem persists, see "

Troubleshooting the

Battery

."

Time-of-day not set

The time or date displayed in the system configuration
information does not match the system clock.

Enter

System Setup

and correct the date or time.

Timer chip counter 2
failed

A chip on the system board might be malfunctioning.

Run the System Board Devices tests in the

Dell

Diagnostics

.

Unexpected interrupt
in protected mode

The keyboard controller may be malfunctioning, or one
or more RIMMs may be loose.

Run the System Memory and the Keyboard tests in
the

Dell Diagnostics

.

WARNING:Dell's Disk
Monitoring System
has detected that
drive [0/1] on the
[primary/secondary]
EIDE controller is
operating outside
of normal
specifications. It
is advisable to
immediately back up
your data and
replace your hard-
disk drive by
calling your
support desk or
Dell Computer
Corporation.

POST has queried the EIDE drive for status
information. The drive has returned a parameter from
the call that indicates it has detected possible error
conditions for its operating specifications.

When your computer finishes booting, immediately
back up your data and replace your hard-disk drive.
Restore the data to the replaced drive.

If a replacement drive is not immediately available and
the drive is not the only bootable drive, enter

System

Setup

and change the appropriate drive setting to

None. Remove the drive from the system. This should
be done only after you have backed up the data.

Write fault

The operating system cannot write to the diskette or

See "

Troubleshooting Drives

."