Dell Vostro 410 (Late 2008) - Manual (Page 6)

9. Connect any cables that should be attached to the card.
10. See the documentation for the card for information about the card's cable connections.
11. Perform the steps in the procedure After Working on Your Computer .
12. Install any drivers required for the card as described in the card documentation.
Configuring Your Computer After Removing or Installing a PCI or PCI Express Card
Back to Contents Page
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly or
cause damage to the equipment.
NOTE: For information on location of connectors, see the Setup and Quick Reference Guide. For information on installing drivers and software for your
card, see the documentation that shipped with the card.
Installed Removed
Sound
Card 1. Enter system setup (see
Entering System Setup )
2. Go to Integrated
Peripherals and select
Onboard Audio Controller,
and then change the
setting to Disabled.
3. Connect the external audio
devices to the sound card's
connectors.
1. Enter system setup
(see Entering System
Setup )
2. Go to Integrated
Peripherals and select
Onboard Audio
Controller, and then
change the setting to
Enabled.
3. Connect the external
audio devices to the
computer's back panel
connectors.
Network
Card 1. Enter system setup (see
Entering System Setup )
2. Go to Integrated
Peripherals and select
Onboard LAN Controller,
and then change the
setting to Disabled, if you
prefer not to use both
interfaces.
3. Connect the network cable
to the network card's
connector.
1. Enter system setup
(see Entering System
Setup )
2. Go to Integrated
Peripherals and select
Onboard LAN
Controller, and then
change the setting to
Enabled.
3. Connect the network
cable to the integrated
network connector.