Optical drive, Replacing or adding a media card reader – Dell Vostro 410 (Late 2008) User Manual
Page 21

4.
Disconnect the FlexBay USB cable from the back of the Media Card Reader and from the internal USB connector on the system board (see
System Board
Components
).
5.
Remove the two screws securing the Media Card Reader.
6.
Slide the Media Card Reader out through the front of the computer.
7.
If you are not reinstalling the Media Card Reader, replace the drive panel insert (see
Replacing the Drive Panel Insert
).
8.
Replace the bezel (see
Replacing the Bezel
).
9.
Perform the steps in the procedure
After Working on Your Computer
.
Replacing or Adding a Media Card Reader
1.
Follow the procedures in
Before Working on Your Computer
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the bezel (see
Removing the Bezel
).
4.
If you are installing a new Media Card Reader rather than replacing a Media Card Reader, remove the break-away metal plate from the FlexBay (see
Removing the FlexBay Break-Away Metal Plate
).
5.
Remove the Media Card Reader from its packaging.
6.
Gently slide the Media Card Reader into the FlexBay slot through the front of the computer.
7.
Align the screw holes in the Media Card Reader with the screw slots in the FlexBay.
8.
Install the two screws to secure the Media Card Reader.
9.
Connect the FlexBay USB cable to the back of the Media Card Reader and to the internal USB connector on the system board (see
System Board
Components
).
10.
Replace the bezel (see
Replacing the Bezel
).
11.
Perform the steps in the procedure
After Working on Your Computer
.
Optical Drive
NOTE:
Ensure that the Media Card Reader is installed before the FlexBay cable is connected.
1
screws (2)
2
screw slots (2)
3
Media Card Reader
4
USB interface cable