Installing the system board, Replacing the support bracket, Et (see "replacing the support bracket" on – Dell Inspiron 531s (Mid 2007) User Manual
Page 164

164
Removing and Installing Parts
Installing the System Board
1 Gently align the board into the chassis and slide it toward the back of the
computer.
2 Using the eight screws, secure the system board to the chassis.
3 Replace the cables that you removed from the system board.
4 Replace the processor and the heat sink assembly (see "Installing the
NOTICE:
Ensure that the heat sink assembly is correctly seated and secure.
5 Replace the memory modules into the memory sockets at the same locations
from which you removed them (see "Installing Memory" on page 113).
6 Replace any add-in cards on the system board.
7 Replace the computer cover (see "Replacing the Computer Cover" on
8 Connect your computer and devices to an electrical outlet, and turn
them on.
9 Verify that the computer works correctly by running the Dell Diagnostics
(see "Dell Diagnostics" on page 84).
Replacing the Support Bracket
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
To replace the support bracket:
1 Align and insert the hinges at the bottom of the support bracket into the
hinge tabs located along the edge of the computer.
2 Pivot the support bracket downward.
3 Align the notch in the support bracket with the slot in the hard drive bay
and press it down.
4 Replace any cable(s) that were attached to the support bracket.
5 Ensure that the support bracket is seated correctly and replace the card
retention bracket.
book.book Page 164 Wednesday, April 16, 2008 3:33 PM