Dell Inspiron 531s (Mid 2007) - Manual (Page 144)

144
Removing and Installing Parts
7 Connect the power and data cables to the drive.
8 Connect the data cable to the system board connector on the system
board.
9 Replace the bezel (see "Replacing the Bezel" on page 124).
10 Replace the computer cover (see "Replacing the Computer Cover" on page 165).
NOTICE:
To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
11 Connect your computer and devices to their electrical outlets, and turn
them on.
See the documentation that came with the drive for instructions on
installing any software required for drive operation.
12 Enter system setup (see "System Setup" on page 172) and select the
appropriate Drive option.
13 Verify that your computer works correctly by running the Dell Diagnostics
(see "Dell Diagnostics" on page 84).
Battery
Replacing the Battery
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge
static electricity from your body before you touch any of your computer’s electronic
components. You can do so by touching an unpainted metal surface on the
computer chassis.
A coin-cell battery maintains computer configuration, date, and time
information. The battery can last several years. If you have to repeatedly reset
time and date information after turning on the computer, replace the battery.
CAUTION:
A new battery can explode if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer.
Discard used batteries according to the manufacturer’s instructions.
book.book Page 144 Wednesday, April 16, 2008 3:33 PM