Dell POWEREDGE M1000E - Manual (Page 62)

42 Access Gateway Administrator’s Guide
53-1002743-01
Port Grouping policy
3
FIGURE 10 Port group 1 (PG1) setup
Adding an N_Port to a port group
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --pgadd command with the appropriate options to add an N_Port to a specific
port group. In the following example, N_Port 14 is added to port group 3.
Note that if you add more than one N_Port, you must separate them with a semicolon.
switch:admin> ag --pgadd 3 14
N_Port[s] are added to the port group 3
Deleting an N_Port from a port group
Before deleting an N_Port, all F_Ports mapped to the N_Port should be remapped before the
N_Port is deleted from a port group.
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --pgdel command with the appropriate options to delete an N_Port from a
specific port group. In the following example, N_Port 13 is removed from port group 3.
switch:admin> ag --pgdel 3 13
N_Port[s] are deleted from port group 3
3. Enter the ag --pgshow command to verify the N_Port was deleted from the specified port
group.
Removing a port group
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --pgremove command with the appropriate options to remove a port group. In
the following example, port group 3 is removed.
switch:admin> ag --pgremove 3
F_Port1
N_Port1
F_Port2
F_Port3
N_Port2
F_Port4
PG1 AG
Fabric-1
Fabric-2
Storage
Array