beautypg.com

Dell Inspiron 6400 User Manual

Page 80

background image

80

Solving Problems

The computer runs the Pre-boot System Assessment, a series of initial tests of your system board,
keyboard, hard drive, and display.

During the assessment, answer any questions that appear.

If a failure is detected, the computer stops and beeps. To stop the assessment and restart the
computer, press ; to continue to the next test, press ; to retest the component that
failed, press .

If failures are detected during the Pre-boot System Assessment, write down the error code(s) and
contact Dell.

If the Pre-boot System Assessment completes successfully, you receive the message

Booting Dell

Diagnostic Utility Partition. Press any key to continue

.

4 Press any key to start the Dell Diagnostics from the diagnostics utility partition on your hard drive.

Starting the Dell Diagnostics From the Drivers and Utilities CD

1 Insert the Drivers and Utilities CD.
2 Shut down and restart the computer.

When the DELL logo appears, press immediately.

If you wait too long and the Windows logo appears, continue to wait until you see the Windows
desktop. Then shut down your computer and try again.

NOTE:

The next steps change the boot sequence for one time only. On the next start-up, the computer boots

according to the devices specified in the system setup program.

3 When the boot device list appears, highlight CD/DVD/CD-RW Drive and press .
4 Select the Boot from CD-ROM option from the menu that appears and press .
5 Type

1

to start the ResourceCD menu and press to proceed.

6 Select Run the 32 Bit Dell Diagnostics from the numbered list. If multiple versions are listed, select

the version appropriate for your computer.

7 When the Dell Diagnostics Main Menu appears, select the test you want to run.

Dell Diagnostics Main Menu

1 After the Dell Diagnostics loads and the Main Menu screen appears, click the button for the option

you want.

Option

Function

Express Test

Performs a quick test of devices. This test typically takes
10 to 20 minutes and requires no interaction on your
part. Run

Express Test first to increase the possibility of

tracing the problem quickly.

book.book Page 80 Friday, June 29, 2007 4:59 PM

This manual is related to the following products: