Dell PowerEdge RAID Controller S100 - Manual (Page 43)

Installing the Drivers 43
For Microsoft Windows Server 2003:
a Insert the floppy disk that contains the files copied at "Downloading
the Controller Driver Media" on page 37. (An external USB floppy
disk drive can be used, if your system does not have a built-in floppy
disk drive).
b Press on the keyboard, when prompted at the beginning of the
Windows setup.
c Wait until the Windows Setup window with S = Specify
Additional Device appears. Press on the keyboard.
d Insert the requested media disk (as applicable) and press .
6 At the next Select the driver to be installed window, select Dell PERC
S100 S300 Controller... Click Next to load the driver files.
For Microsoft Windows Server 2003:
When you are asked to load additional drivers, press to start the
Microsoft Windows installation process.
7 From the list at the Select the operating system you want to install
window, select the applicable operating system. Click Next.
8 Perform the remaining operating system installation instructions. Some of
the windows require user-specific password and system information. As
required, contact your IT administrator for assistance.
For Microsoft Windows Server 2003 only: Two warning dialog boxes
appear during the Installing Windows segment of the installation:
• At the Software Installation dialog box, click Yes.
• At the
Hardware Installation dialog box, click Yes.
NOTE: When the operating system installation process is finished, remove the
installation media inserted in step 5.
A5_bk0.book Page 43 Thursday, February 10, 2011 8:34 PM