4 create a bootable virtual disk, C select continue to boot and press
Page 40

Installing the Drivers

Create a bootable

virtual disk

Check controller

options and the boot

list priority

At the PERC S100 Virtual Disk Management utility or

PERC S300 Virtual Disk Management utility, use the

arrow keys to select Controller Options. Press

. Make sure that Toggle INT13 Boot
Support is ON. Press to exit.

At the Virtual Disks field, make sure the bootable

virtual disk created in Procedure 4, is the first virtual

disk listed.

If the bootable virtual disk is not the first virtual disk

NOTE:

If Non-Raid virtual disks are used (and appear in the

Virtual Disks list), the Swap Two Virtual Disks option

is enabled only if the system contains an initialized physical

disk.

Select Continue to Boot and press .

NOTE:

If the next Procedure (6) is not applicable, continue

with one of the following procedures:

Table 5-2. Pre-Installation Procedures For The Controller Drivers

(continued)

Procedure

Steps

A5_bk0.book Page 40 Thursday, February 10, 2011 8:34 PM

Page 40