D to change the sequence of other devices, E press to exit – Dell PowerEdge RAID Controller S100 User Manual

Page 41

Installing the Drivers

Change the Boot
Priority List
for Devices (if

applicable)

To change the order of the devices (CD-ROM, optical

DVD, and so on), perform the following:

NOTE:

Unless mentioned otherwise, the term PERC Virtual

Disk Management utility refers to both the PERC S100 Virtual

Disk Management utility and the PERC S300 Virtual Disk

Management utility.

NOTE:

If the PERC Virtual Disk Management utility is open,

select Continue to Boot, then press . Press

to reboot the system.

Boot the system. When the POST screen appears,

press .

At the Dell PowerEdge System screen, use the arrow

keys to scroll to Boot Sequence. Press .

Make sure that Hard drive C: is the first device

listed.

To change the sequence of other devices:

•Use the <+> key to move devices up, or the <-> key

to move devices down.

•Use the space bar to enable or disable a device.

Press to exit.

Press again. Select Save Changes and
Exit and press .

NOTE:

Continue with one of the following procedures:

Table 5-2. Pre-Installation Procedures For The Controller Drivers

(continued)

Procedure

Steps

A5_bk0.book Page 41 Thursday, February 10, 2011 8:34 PM