Dell XPS One 2710 (Mid 2012) - Manual (Page 99)

Removing the I/O-Board | 99
44 Removing the I/O-Board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Prerequisites
1 Remove the back cover. See "Removing the Back Cover" on page 19.
2 Remove the stand. See "Removing the Stand" on page 47.
3 Remove the trim cover. See "Removing the Trim Cover" on page 87.
4 Remove the I/O panel. See "Removing the I/O Panel" on page 91.
5 Remove the system-board shield. See "Removing the System-Board Shield" on
page 31.
6 Remove the inner frame. See "Removing the Inner Frame" on page 95.
Procedure
1 Remove the screws that secure the I/O-board assembly to the computer base.
2 Gently lift the I/O-board assembly from the computer base and turn the I/O-board
assembly over.
3 Press the securing clip and disconnect the power-port cable.
4 Note the routing of the TV-in port cable, infrared-emitter port cable, and the
power-supply light cable, and then disconnect the cables from the system board.
1 screws (9) 2 I/O-board assembly
1
2
OM_Book.book Page 99 Friday, April 27, 2012 3:23 PM