Dell XPS One 2710 (Mid 2012) - Manual (Page 25)

Replacing the Converter Board | 25
7 Replacing the Converter Board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Align the screw holes on the converter board with the screw holes on the
computer base.
2 Replace the screws that secure the converter board to the computer base.
3 Connect the converter cable to the converter board.
4 Connect the display-backlight cable to the convertor board and secure the tab.
Postrequisites
1 Replace the back cover. See "Replacing the Back Cover" on page 21.
OM_Book.book Page 25 Friday, April 27, 2012 3:23 PM