Dell XPS One 2710 (Mid 2012) - Manual (Page 155)

Replacing the Antenna Module(s) | 155
69 Replacing the Antenna Module(s)
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Align the antenna modules with the alignment posts on the computer base and
adhere the antenna modules to the computer base.
2 Route the wireless-antenna cables through their routing guides and connect the
wireless-antenna cables to the wireless mini-card.
Postrequisites
1 Follow step 8 to step 19 in "Replacing the Display Panel" on page 139.
2 Replace the inner frame. See "Replacing the Inner Frame" on page 97.
3 Replace the processor heat-sink fan. See "Replacing the Processor Heat-Sink Fan"
on page 77.
4 Replace the trim cover. See "Replacing the Trim Cover" on page 89.
5 Replace the system-board shield. See "Replacing the System-Board Shield" on
page 33.
6 Replace the stand. See "Replacing the Stand" on page 49.
7 Replace the back cover. See "Replacing the Back Cover" on page 21.
OM_Book.book Page 155 Friday, April 27, 2012 3:23 PM