Dell XPS One 2710 (Mid 2012) - Manual (Page 97)

Replacing the Inner Frame | 97
43 Replacing the Inner Frame
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Align the screw holes on the inner frame with the screw holes on the computer
base.
NOTE: Ensure that all cables are routed through their routing guides and
no cables are placed between the inner frame and the computer base.
2 Replace the screws that secure the inner frame to the computer base.
Postrequisites
1 Replace the I/O panel. See "Replacing the I/O Panel" on page 93.
2 Replace the trim cover. See "Replacing the Trim Cover" on page 89.
3 Replace the system-board shield. See "Replacing the System-Board Shield" on
page 33.
4 Replace the stand. See "Replacing the Stand" on page 49.
5 Replace the back cover. "Replacing the Back Cover" on page 21.
OM_Book.book Page 97 Friday, April 27, 2012 3:23 PM