Dell XPS One 2710 (Mid 2012) - Manual (Page 123)

Removing the Side I/O-Board | 123
56 Removing the Side I/O-Board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Prerequisites
1 Remove the back cover. See "Removing the Back Cover" on page 19.
2 Remove the stand. See "Removing the Stand" on page 47.
3 Remove the trim cover. See "Removing the Trim Cover" on page 87.
4 Remove the I/O panel. See "Removing the I/O Panel" on page 91.
5 Remove the system-board shield. See "Removing the System-Board Shield" on
page 31.
6 Remove the inner frame. See "Removing the Inner Frame" on page 95.
7 Follow step 1 to step 6 in "Removing the I/O-Board" on page 99.
8 Disconnect the antenna cables from the wireless mini-card. See "Removing the
Wireless Mini-Card" on page 67.
9 Remove the processor heat-sink. See "Removing the Processor Heat-Sink" on
page 79.
10 Follow step 1 to step 3 in "Removing the System Board" on page 111.
OM_Book.book Page 123 Friday, April 27, 2012 3:23 PM