Dell D/Dock Expansion-Station - Manual (Page 13)

Using the Module Bay
You can install any module from your computer, such as a floppy drive or CD drive, in the module bay of the D/Dock
expansion station. You can also charge a second D-series battery from your computer.
NOTICE: To avoid damaging the expansion station or the module, do not install any device in the expansion-station
module bay that you do not normally use in your computer.
Installing a Device in the Module Bay
1. Save and close any open files, exit any open programs.
1 module
2 latch release
2. Push the module firmly into the bay and push in the latch release to seat the module.
3. Verify that the device is properly seated. If it is not, remove the module and reseat it.
Removing a Device From the Module Bay
NOTE: The slide lock on the right side of the expansion station must be in the unlocked position before you remove a
device from the module bay.