beautypg.com

Modem regulatory information, Fax branding – Dell D/Dock Expansion-Station User Manual

Page 19

background image

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

manufacturer's instruction manual, may cause interference with radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

The following information is provided on the device or devices covered in this document in compliance with FCC regulations:

Model number: PD01X

Company name:

Dell Computer Corporation

One Dell Way

Round Rock, Texas 78682 USA

512-338-4400

Modem Regulatory Information

This equipment complies with Part 68 of the FCC rules. On the bottom of your computer is a label that contains, among other

information, the FCC registration number and ringer equivalence number (REN) for your equipment. If requested, you must

provide this information to the telephone company.

The REN is used to determine the quantity of devices that may be connected to the telephone line. Excessive RENs on the

telephone line may result in the devices not ringing in response to an incoming call. In most areas, the sum of all the RENs on

your telephone line should be less than five to ensure proper service from the telephone company. To be certain of the

number of devices that you may connect to a line, as determined by the total RENs, contact your local telephone company.

The registration jack Universal Service Order Code (USOC) used by this equipment is RJ-11C. An FCC compliant telephone

cord and modular plug is provided with this equipment. This equipment is designed to be connected to the telephone network

or premises wiring using a compatible modular jack that is Part 68 compliant.

This equipment cannot be used on public coin-phone service provided by the telephone company. Connection to party line

service is subject to state tariffs.

There are no user serviceable parts on the modem contained in your computer.

If your telephone equipment causes harm to the telephone network, the telephone company will notify you in advance that

service may be temporarily discontinued. If advance notice is not practical, the telephone company will notify you as soon as

possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the

operation of this equipment. If this happens, the telephone company will provide advance notice in order for you to make

necessary modifications to maintain uninterrupted service.

If you experience trouble with this telephone equipment, refer to your computer's troubleshooting documentation or, for some

computers, the section titled "Contacting Dell" in your computer's online guide to find the appropriate telephone number for

obtaining customer assistance. If the equipment is causing harm to the telephone network, the telephone company may

request that you disconnect the equipment until the problem is resolved.

Fax Branding

The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic

device, including fax machines, to send any message unless such message clearly contains in a margin at the top or bottom

of each transmitted page or on the first page of the transmission, the date and time it is sent, identification of the business,

other entity, or individual sending the message, and the telephone number of the sending machine or such business, other

entity, or individual. The telephone number provided may not be a 900 number or any other number for which charges exceed