Dell Precision T3400 (Late 2007) - Manual (Page 84)

84
System Setup
SMART Reporting
(Off default)
Specifies whether hard drive errors for internal drives are
reported during system startup.
• Off — Errors are not reported.
• On — Errors are reported.
Onboard Devices
Integrated NIC
(On default)
Enables or disables the integrated network interface controller
(NIC).
• Off — The integrated NIC is disabled.
• On — The integrated NIC is enabled.
• On w/PXE — The integrated NIC is on (with PXE enabled).
• On w/RPL — The integrated NIC is on (with RPL enabled).
NOTE:
PXE or RPL is required only if you are booting to an
operating system located on another computer. If a boot routine is
not available from the remote system, the computer attempts to
boot from the next device listed in the boot sequence.
Integrated Audio
(Auto default)
Enables or disables the integrated audio controller.
• Off — Integrated audio is disabled.
• Auto — Use the add-in Audio controller.
• On — Integrated audio is enabled.
USB Controller
(On default)
Enables or disables the internal USB controller.
• Off — The USB controller is disabled.
• On — The USB controller is enabled.
• No Boot — The USB controller is enabled; however, the BIOS
will not recognize USB storage devices.
NOTE:
Operating systems with USB support will recognize USB
storage devices regardless of the No Boot setting.
Rear Quad USB
(On default)
Enables or disables the rear quad USB ports.
• Off — The USB group is disabled.
• On — The USB group is enabled.
Rear Dual USB
(On default)
Enables or disables the rear dual USB ports.
• Off — The USB group is disabled.
• On — The USB group is enabled.