Dell Precision T3400 (Late 2007) - Manual (Page 196)

196
Adding and Replacing Parts
To install a SAS hard drive:
a Connect the power cable to the SAS connector.
b Connect the SAS connector to the hard drive.
c Connect the other end of the SAS cable to the SAS controller card.
9 Ensure that all connectors are properly cabled and firmly seated.
10 Replace the computer cover (see "Replacing the Computer Cover" on
page 262).
NOTICE:
To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
1 serial ATA cable 2 SATA0 connector
3 SATA1 connector 4 power cable
5 secondary hard drive bay 6 hard drive in primary hard drive
bay
6
4
1
2
5
3