Dell PowerEdge SC 440 - Manual (Page 73)

Installing System Components
73
Bezel
Removing the Bezel
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 41.
3 Remove the heat sink and shroud assembly. See "Removing the Processor" on page 62. Do not remove
the processor, however.
4 Remove the large processor cooling fan. See "Removing the Cooling Fans" on page 65.
5 Remove the three bezel release screws. See Figure 3-21.
6 Slide the bezel toward the top of the system, then lift it outward.
book.book Page 73 Tuesday, August 25, 2009 1:14 PM