Dell PowerEdge 2650 - Manual (Page 40)

Performing a Memory Upgrade
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the cover (see " Removing the Cover ").
3. Install or replace the memory module pairs as necessary to reach the desired memory total (see " Installing Memory Modules " and " Removing Memory
Modules ").
See Figure 5 -3 to locate the memory module connectors.
4. Replace the cover (see " Replacing the Cover ").
5. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
After the system completes the POST routine, it runs a memory test.
The system detects that the new memory does not match the system configuration information, which is stored in NVRAM. The monitor displays an error
message that ends with the following words:
Press to continue; to enter System Setup
6. Press to enter the System Setup program, and check the System Memory setting.
The system should have already changed the value in the System Memory setting to reflect the newly installed memory.
7. If the System Memory value is incorrect, one or more of the memory modules may not be installed properly. Repeat steps 1 through 6, ensuring that
the memory modules are firmly seated in their connectors.
8. Run the system memory test in system diagnostics.
Installing Memory Modules
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the cover (see " Removing the Cover ").
3. Locate the memory module connectors in which you will install a memory module (see Figure 5 -3 ).
4. Press down and outward on the memory module connector ejectors, as shown in Figure 4 -14 , to allow the memory module to be inserted into the
connector.
Figure 4-14. Removing and Installing a Memory Module
Total Desired
Memory BANK1 BANK2 BANK3
A B A B A B
256 MB 128 MB 128 MB None None None None
512 MB 256 MB 256 MB None None None None
1 GB 512 MB 512 MB None None None None
2 GB 512 MB 512 MB 512 MB 512 MB None None
2 GB 1 GB 1 GB None None None None
3 GB 1 GB 1 GB 512 MB 512 MB None None
6 GB 1 GB 1 GB 1 GB 1 GB 1 GB 1 GB
NOTE: This table only lists sample memory module configurations. Not all possible configurations are listed.
CAUTION: Before you perform this procedure, read the safety instructions in your System Information document.
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System Information document.
CAUTION: Before you perform this procedure, read the safety instructions in your System Information document.
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System Information document.