Dell Intel PRO Family of Adapters - Manual (Page 5)

MultiPoint Mode
If more than two ENodes are detected in the VN2VN fabric, then all nodes should operate in Multipoint mode:
Installation Overview
For information on System Requirements see System Requirements .
1. Install FCoE-capable adapters in the system. For a list of supported adapters, see Supported Intel® Network Adapters .
2. After following the above step if you are having problems, refer to Known Issues .
FCoE Infrastructure - Installation and Configuration
The following is a typical FCoE setup flow:
1. Typical FCoE-enabled Fabric Switch Configuration .
2. If you want to boot from an FCoE LUN:
See Intel® Ethernet FCoE Boot Configuration
Configure Intel® Ethernet FCoE Boot Options from Intel® PROSet for Windows* Device Manager
3. Install operating system:
Linux Installation and Configuration
Microsoft* Windows* Server Installation and Configuration
4. Configure Intel Ethernet FCoE/DCBx:
Configure DCBx
Configure FCoE
Please read all restrictions and disclaimers .
Back to Contents Page