Acronis Backup for Windows Server Essentials - Installation Guide - Manual (Page 45)

45 Copyright © Acronis International GmbH, 2002-2014
How to get packages for Linux
Download the required installation files (.i686 or .x86_64) from the Acronis website and put them on
the machine from which they are to be taken by the software.
If you are planning to install Acronis components on both Windows and Linux machines, put the
packages for Linux into the directory where the packages for Windows are. This will help you
configure installation of Acronis components on Windows and Linux machines at the same time.
2.3.2 Preparation
On machines running Windows
1. Make sure that the machines meet the system requirements (p. 15).
2. For successful installation on a remote machine running Windows XP or later, the option Control
panel > Folder options > View > Use simple file sharing (for Windows XP) or Control panel >
Folder options > View > Use Sharing Wizard (in Windows Vista or later) must be disabled on that
machine.
3. For successful installation on a remote machine that is not a member of an Active Directory
domain, User Account Control (UAC) must be disabled (p. 45).
4. File and Printer Sharing must be enabled on the remote machine. To access this option:

On a machine running Windows XP with Service Pack 2 or Windows 2003 Server: go to
Control panel > Windows Firewall > Exceptions > File and Printer Sharing.

On a machine running Windows Vista, Windows Server 2008, or Windows 7: go to Control
panel > Windows Firewall > Network and Sharing Center > Change advanced sharing
settings.
5. Acronis Backup uses TCP ports 445 and 25001 for remote installation. Also, it uses TCP port 9876
for remote installation and for communication between the components.
Port 445 is automatically opened when you enable File and Printer Sharing. Ports 9876 and
25001 are automatically opened through Windows Firewall. If you use a different firewall, make
sure that these three ports are open (added to exceptions) for both incoming and outgoing
requests.
After the remote installation is complete, you can remove ports 445 and 25001 from exceptions.
Port 25001 is automatically closed through Windows Firewall. Port 9876 needs to remain open.
On machines running Linux
1. Make sure that the machines meet the system requirements (p. 15).
2. Check that each of the machines meets the prerequisites for local installation of Agent for Linux
(p. 38), except for the "Installation files" step.
3. Make sure that TCP port 22 is opened and that the SSH daemon is running on each of the
machines. After the remote installation is complete, you can close the port and stop the SSH
daemon.
4. Open TCP port 9876 on each of the machines. Acronis Backup uses this port for communication
between the components; therefore, it must remain open for both incoming and outgoing
requests.
2.3.2.1 Requirements on User Account Control (UAC)
On a machine that is running Windows Vista or later and is not a member of an Active Directory
domain, centralized management operations (including remote installation) require that UAC be
disabled.