Canon eos rebel g - Manual (Page 65)

VI. Reference
AF control TTL-CT-SIR (Through-the-Lens Cross-Type Secondary Image
Registration) with multiple BASIS (Base-Stored Image Sensor).
© One-Shot AF: AF locks when focus is achieved. Shutter can be
released only when focus is achieved.
© At Focus AF: Switches between One-Shot AF mode and Al Servo
AF automatically.
(§) Manual focusing: Enabled by setting the lens’ focus mode switch to
"M” and turning the focusing ring.
AF working range EV 1,5-18 (at ISO 100, standard chart)
Focusing point selection © Automatic: Camera-selected.
@ Manual: User-selected.
AF-assist beam Built-in AF-assist beam emitted automatically
Shutter Vertical-travel, focal-piane shutter with all speeds electronically-
controlled,
Shutter speeds 30 to 1/2000 sec, (in half steps) and bulb. X-sync at 1/90 sec,
Self-timer Electronicaily-controlied for 10-sec. delay.
Film loading Automatic, After film is loaded and the back is closed, the film is pre­
wound.
Film advance Automatic.
© Single-frame
© Continuous (Max. 1 frame per sec.)
Film rewind Automatic at the end of the roll. Midroll rewind possible.
Built-in flash Built-in, retractable flash head in the pentaprism with TTL autoflash
system, serially controlled.
© Guide No. 12 (in meters at ISO 100)
© Recycling time: Approx. 2 sec.
© Flash coverage: 28mm lens covered.
Flash contacts X-sync for direct connection on hot shoe.
Power source Two DL123A (or CR123A) lithium batteries.
Battery check Battery level displayed automatically when Command Dial is set to any
mode except the Function Set Zone.
Dimensions (mm) 145.7 (W) x 92 (H) x 61.9 (D)
Weight 370 g (Body only, excluding batteries) j