Canon eos rebel g - Manual (Page 15)

p
__ I. Before You Start
A Hold down the film cartridge and
^ pull the edge of the film leader to
the orange mark on the camera.
• If the edge of the film leader goes beyond
the orange mark, rewind some of the film
back into the cartridge.
C After checking that the film leader
^ edge is correctly aligned with the
orange mark, close the camera
back. The film will then wind on the
spool and the frame counter will
count up. The camera will then
make a shutter release sound and
the film symbol (@) will be
displayed.
* While the film is being wound, the ISO film
speed will be displayed on the LCD panel.
■ If the film has not been loaded properly,
the frame count will not be displayed and
the film symbol will blink. Load the film
again.
Unloading Film
After the film’s last frame is exposed,
the camera rewinds the film
automatically. When the film rewind
ends, only the film symbol will blink on
the LCD panel.
Check that the film symbol is blinking,
then open the camera back and
unload the film.
• The film symbol will blink for 3 seconds, then it
will stay on.
15