Dynalco SWT-2000 Speed Switch/Speed Transmitter - Manual (Page 24)

Operating Instructions SWT-2000 DYNALCO
20
6.7.9 Relay Outputs
To configure relay outputs go to , .
Relay configuration consists of:
Assignment, the Latch Function and the Fail safe/Not fail safe mode.
Possible relay assignment:
Latch Function: Latched / not latched
Safety function: Fail safe / Not fail safe
System limit 1 Sensor Error
System limit 2 Static S1
System limit 3 Static S2
System limit 4 Dynamic error
System limit 5 Always ON
System limit 6 Always OFF
Assignment selection
The selection box is used to choose relay assignment.
Latch Function
Defines whether a relay state should be held until reset.
Safety Function
Defines whether the relay is to operate in Fail safe (deactivate at limit) or not fail safe mode (activate at limit).
6.7.10 Open Collector Outputs
To configure Open Collector outputs go to , .
Open Collector configuration consists of:
Assignment, the Latch Function and the Fail safe/Not fail safe mode.
Possible Open Collector assignment:
System Limit 1 Static S2
System Limit 2 Dynamic error
System Limit 3 Always ON
System Limit 4 Always OFF
System Limit 5 Frequency S1
System Limit 6 Frequency S2
Sensor Error Frequency x2
Static S1 Frequency x4
Latch Function:
Latched / not latched
Safety mode: Fail safe / Not fail safe
Assignmment selection
The selection box is used to choose Open Collector assignment.
Latch Function