Installation, Connections, 1 front view – Dynalco SWT-2000 Speed Switch/Speed Transmitter User Manual
Page 13
Operating Instructions SWT-2000
DYNALCO
9
4. Installation
The SWT-2000 may only be installed by competent personnel. Only undamaged and correctly configured units
may be used.
Before switching on, check that the supply is within the permissible range.
The Sensor cable screens must be connected terminals „Sh1“ and „Sh2“ respectively so as to minimize the
effects of signal noise. These terminals are internally connected with 0V.
Attention:
If the password has been changed, there is no way of returning to a factory setup. If the password
is forgotten, the unit will need to be returned to Dynalco for re-programming.
5. Connections
5.1 Front View
5.1.1 Front View SWT-2000
The Ethernet Interface, status LED along with the FUNC push button are located at the front. For
communications, see Paragraph 6 Configuration via PC Software
Terminal B
Terminal A