Dynalco SWT-2000 Speed Switch/Speed Transmitter - Manual (Page 16)

Operating Instructions SWT-2000 DYNALCO
12
6. Configuration via PC Software
6.1 Software Concept
The SWT-2000 Ethernet connection is used to configure or interrogate the unit. (see Paragraph 9
Accessories) The resident menu driven configuration software is used for unit set up.
Normal PC file handling procedures apply and the configuration file can be communicated between computer
and SWT-2000.
To run the Software you must have Java Runtime Environment (JRE) 1.5 or higher.
6.2 PC Settings
The PC Ethernet card must first be set correctly. SWT-2000’s cannot be used on a network.
Go to Desktop, Settings, Network connections and right click on . Right click the Network card
you want to use for SWT-2000 comms and select .
Select Internet protocol (TCP/IP) and select the Option
6.3 Download Configuration Software
Connect the Tachometer to your PC using a cross over patch cable. Once connected open your browser and
enter the IP address 192.168.1.127/software
An HTML page will open with the Link
Click on the Link. Dependent upon your Internet Explorer configuration you will be asked whether you want to
(Run) or (Save as) the program.
Direct Execution
Select and the configuration will be read from the tachometer (can take a few seconds). Once loaded
the configuration software will open automatically.
Save As
Select to save the file in a path of your choice (can take a few seconds).
Open the file from your PC. The configuration software establishes a connection to the SWT-2000 and reads
the actual parameters.