Small form factor, Removing the computer cover, Inside your computer – Dell OptiPlex 760 User Manual
Page 141
Back to Contents Page
Small Form Factor
Dell™ OptiPlex™ 760 Service Manual
Removing the Computer Cover
1.
Follow the procedures in
Working on Your Computer
.
2.
If you have installed a padlock through the padlock ring on the back panel, remove the padlock.
3.
Slide the release latch back as you lift the cover.
4.
Pivot the cover up using the bottom hinges as leverage points.
5.
Remove the cover from the hinge tabs and set it aside on a soft nonabrasive surface.
Inside Your Computer
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.
1 security cable slot 2 cover release latch
3 padlock ring
4 computer cover
WARNING:
Graphics card heat sinks can become very hot during normal operation. Ensure that a graphics card heat sink has had sufficient time
to cool before you touch it.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
To avoid electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.