Bio-Rad SmartSpec Plus Spectrophotometer - Manual (Page 55)

• Trim leading edge of paper roll with scissors if uneven or torn.
• Feed paper into slot opening until it stops. Press the "Paper Feed" key located on the
keypad and guide the paper into the printer until it grabs and self feeds.
• Continue to press "Paper Feed" button until paper comes out of printer outlet located on
top of case as shown.
• Wind any excess paper back on roll and drop new paper roll with shaft into grooves in
paper storage area as shown.
• Re-install printer door cover.
Tearing Paper
• When tearing off print outs, always tear paper forward against serrated edge of printer
outlet as shown on previous page.
Section 10
Specifications
Characteristic SmartSpec Plus Specification
Light Source Xenon lamp
Detector Photodiode array
Display 2 x 24 alphanumeric backlit LCD
Printer Built-in alphanumeric printer
Interface RS-232 serial port
Wavelength Range 200 to 800 nm
Wavelength Accuracy (18–27°C) < ±1.0 nm from 200–250, 300–800 nm
< ±0.5 nm from 250 to 300 nm
Spectral Bandwidth <5 nm
Absorbtion Accuracy ±0.01 @ 0.5 AU
±0.02 @ 1.0 AU
Absorbtion Repeatability ±0.005 @ 0.5 AU
Stray Light <0.2% @ 230 nm using NaI Standard
Operating Temperature 15 to 35°C
Beam Height (Z-dimension) 8.5 mm
Dimensions 33 x 26 x 14 cm (W x D x H)
Weight ~3.9 kg
Power Requirement 90–260 VAC, 47–63 Hz
Regulatory CE, TЬV
52