Great Plains NTA2000D Operator Manual - Manual (Page 43)

Multi-function Drill Control
38c
Channel Indicator
The indicator is used to indicate the channel to which the information on the display relates.
Normal Display Mode
The instrument has a normal display mode displaying six work functions. Select a channel by pressing the
button once or more.
When the drill is moving, the selected channel is displayed for 10 seconds before defaulting back to the
tramline bout display ( channel). When the drill is stationary the instrument will flash between forward
speed and the Tramline channel. If the tramline option is turned off, the instrument will simply default to the
Forward Speed channel.
Programming Modes
There are 3 programming modes with various calibration factors and default settings.
Many of these settings are made on installation and do not normally need to be changed unless the
instrument is switched onto a different drill. These settings are appended to the back of this section. The
operator does not normally need to refer to them.
Units
The instrument can be set to display metric or imperial units. To see which is selected, select either the
forward speed ( ) channel or the area channel ( ) , then press and hold the button.
Either the top row of horizontal segments or the bottom row of horizontal segments will briefly display,
indicating the units selected.
NOTE: ‘MET’ and ‘IMP’ are printed on the instrument front panel on most instrument variants.