Great Plains NTA2000D Operator Manual - Manual (Page 23)

21 9/13/2006 NTA 2000D 148-632M
Great Plains Mfg., Inc.
Folding the Drill
!
WARNING!
Pinch Point and Crushing Hazard. To prevent serious injury or
death. Be certain the drill is hitched securely to your tractor
drawbar and the hitch safety chain is securely attached to the
tractor before raising or folding the drill.
• Always lift drill when before folding.
• Fold only if hydraulics are bled free of air and fully charged
with hydraulic oil.
• Keep away and keep others away when folding or unfolding
drill.
Coulter Wing Frame
Refer to Figure 11
8. Remove lock pins from lock links
Refer to Figure 12
9. Store lock pins in storage hole as shown. Flip up lock
links to keep the drill transport width below 118” (3
meters).
10. Allow tongue and transport cylinders to settle back
against the lock channels.
!
DANGER!
Electrocution hazard. To prevent serious injury or death from
electric shock, keep clear of overhead power lines when trans-
porting, folding, unfolding or operating all air-drill compo-
nents. Machine is not grounded. Electrocution can occur
without direct contact.
11. Fold opener and coulter wings.
Refer to Figure 13
12. Install opener wing frame lock pin to keep opener wing
frames secure in their transport position.
Figure 11
Coulter Extension
Figure 12
Lock Link Pin Storage
19736
19738
Figure 13
Opener Wing Frame Lock Pin
19736