Great Plains ADC2350BE Operator Manual - Manual (Page 76)

72 ADC2350/E and ADC2350B/BE Table of Contents Index Great Plains Manufacturing, Inc.
167-085M Table of Contents Index 2012-08-01
Planting too much Meter setting too high Re-check against chart & calibration.
Incorrect cart setup sprockets for
implement Re-check against page 19.
Seed size and weight vary from chart Calibrate. Adjust rate to compensate.
Actual field size is different Verify field size.
Excessive overlap or irregular shaped
field Adjust implement marker.
Incorrect tire size or air pressure Check tire size and air pressure, page 87.
Meter sprocket damaged Replace if damaged.
No Seed Flow Seed monitor Master Switch off Engage seed monitor.
Height switch out of adjustment or
failed. Check, adjust or replace height switch.
Chain broken or removed Inventory chains against routing diagrams.
Clutch failed Replace clutch. On an emergency basis, use the
clutch lock-up procedure on page 70.
Clutch circuit failed Replace failed component or cable. On an
emergency basis, use the clutch lock-up
procedure on page 70.
Seed rate set to zero Check seed rate indicator at meter(s).
Sprocket loose on shaft Check all sprocket pins, keys and set screws.
Meter box completely plugged Have Parts Manual at hand for parts identification.
Remove chain drive to meter. Remove bolts
holding meter box to bottom of hopper. Remove
and clean out meter.
Uneven seed
spacing Excessive field speed Reduce speed.
Unclean seed Use clean seed.
Air leaks Check hopper lids, meter seals, manifold caps and
seed hose connections. Adjust latch and/or
replace seals as needed.
Erratic meter clutch Check for damaged cables and loose connections.
Build up of seed treatment in meter. Clean out meter (see above).
Tower blockage Check towers for obstructions and plugging.
Blockages sometimes move from port to port in
towers.
Seed hose plugged Stop and raise drill with fan running. Hand-crank
meter and check for rows not delivering seed.
Meter wheel damaged or worn Check meter sprocket and replace.
Uneven seed
depth Excessive field speed Slow down. Check Seeding Rate Chart for correct
maximum field speed.
Air cart not level Check leveling instructions, page 21.
Planting conditions too wet Wait until drier weather.
Problem Cause Solution