Great Plains ADC2350BE Operator Manual - Manual (Page 63)

Great Plains Manufacturing, Inc. Table of Contents Index Adjustments 59
2012-08-01 Table of Contents Index 167-085M
1. Material Configuration Setup Screen
for Seeds
“Type” - This must be set to “Gran Seed Monitor” to
configure for seeds.
Density Units” - If configured for “U.S.” mode (U.S.
customary units), this is pounds-per-bushel or
pounds-per-cubic-foot. In metric mode this is always
kg/liter.
“Density” - This is the density of seed being planted.
Obtain this information from the material
container/supplier. If unknown, use the value specified in
the rate chart.
“Total Number of Towers” - This is the number of
primary hoses coming off the rear meter box
(typically 4, 5 or 6).
“Calibration Constant” - This is the number listed in the
seed rate charts for the rate you are planting or the
number obtained from running the calibration routine for
your specific seed.
2. Material Configuration Setup Screen
for Fertilizer
“Type” - This must be set to “Gran Fert Monitor” to
configure for fertilizer.
“Density” - Enter the density of Fertilizer being applied,
in pounds-per-cubic-foot (kilograms-per-liter). Obtain this
information from the material container/supplier. If
unknown, use the value specified in the rate chart.
“Total Number of Towers” - This is the number of
primary hoses coming off the rear meter box.
“Calibration Constant” - This is the number listed in the
seed rate charts for the rate you are planting or the
number obtained from running the calibration routine for
your specific fertilizer.
Note: Always enter Density Units before entering the
Density value. Changing the value of Density
Units will alter the value of Density.