Great Plains 2S-2600HDF Operator Manual v2 - Manual (Page 88)

84 2S-2600HD Table of Contents Index Great Plains Manufacturing, Inc.
195-069M Table of Contents Index 2014-02-03
Refer to Figure 83
To disassemble unscrew end cap of filter. Remove top
retaining washer and screen.
Clean filter screen with solvent and compressed air, or
replace if needed.
When reassembling put screen into filter. Place retaining
washer on top of filter and screw on end cap.
Leveling the Drill
To perform leveling, the drill must be hitched to a tractor,
with at least the hydraulics connected.
Negative Tongue Weight:
Raising openers on unfolded, unhitched drill will cause drill
tongue to rise suddenly, which could cause serious injury or
death. Be certain that drill is hitched securely to your tractor
drawbar and the safety chain is securely attached to tractor
before raising openers and unfolding drill.
Opener Frames Level
Refer to Figure 84
Check that opener frames are level across drill. When
openers are fully raised, top of opener mounts
should
clear bottom of drill frame tube by at least 1 ⁄
2
in (1.3cm).
To adjust opener frames so all openers have same clear-
ance, loosen jam nut
on opener-lift cylinders and turn
adjustment nut . When openers are at correct height,
retighten jam nut. Repeat at each opener-lift cylinder if
necessary.
Figure 83
In-Line Filter
25187
Figure 84
Eyebolt Adjustment
17308
1
2
3
1
2
3