SARGENT Passport 1000 PG Cylindrical Locks - Manual (Page 12)

12 A7808B
Copyright © 2012, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
10/31/12
Passport 1000 PG Cylindrical Lock
13 – Installation of Inside Component Assembly
Insert bottom of Component Assembly first (Fig. 13A), then clip top of
Component Assembly to backplate, verifying both tabs attached securely.
14 – Installation of Connectors
Secure the following connectors onto the circuit board (Fig. 14A
and 14B):
1. Secure the mortise lock body assembly connector (10-pin).
2. Secure the mortise keypad/card reader connector (14-pin).
3. Secure the LCU connector (7-pin).
Notes:
• Connectors go on only one way.
• Do not force and do not offset connectors.
• Be sure they are completely seated (flush).
From
Lock body
Inside of Door
Fig. 13A
Fig. 14A
Fig. 14B (Detail)
Detail 14B
Modular
component
assembly
From Outside Trim (LCU
Card Reader)
From Outside Trim
(Keypad)