Passport 1000 pg exit device, Operational check – SARGENT Passport 1000 PG Exit Devices User Manual

Page 27

10/31/12

A7809B 27

, an ASSA ABLOY Group company

. All rights reser

ved.

Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.

Passport 1000 PG Exit Device

IMPORTANT: Be sure to test functions prior to closing door.
In all cases, perform the following checks:
1. Ensure that inside lever retracts latch (and deadbolt for deadbolt functions).
• For devices with cylinders, the following checks apply:
Insert key into cylinder and rotate:
a. There should be no friction against lock case, wire harness, or any other obstructions.
If harness friction exists, refer to the section on ‘Installation of Inside Component Assembly’

in PERSONA instructions A7809 (this manual).
b. The key should retract the latch and the key should rotate freely.
c. The key should extend and retract the latchbolt.
• For units without a keypad, the following checks apply:
Insert test card marked NO PIN and retract:
a. Ensure lockset displays a green flash (and no other lights).
b. Ensure outside lever retracts latch, the door opens, and that there is no binding against

lock case, wire harness or other obstructions.
• For units with a keypad, test the keypad by using the following checks:
Create and insert a test card marked ’PIN 1234’ and retract:
a. Ensure lockset displays solid yellow light.
b. Type 1, 2, 3, 4 on keypad.
c. Ensure outside lever retracts latch, the door opens, and that there is no binding against

lock case, wire harness or other obstructions.
d. Test again with card marked ’PIN 5678’.
e. Test again with card marked ’PIN 9090’.
2. Any rapid yellow or rapid red flashing lights indicate a low power condition.

Check the battery voltage at the top of the battery pack to check for the required 9V.

If the voltage is correct, inspect the wiring for a possible short.
3. When you have completed the tests, close the door, ensuring latchbolt and deadbolt fully

extend into strike plate without binding.

Operational Check