Tweco VAF4HD Transmig User Manual
Operating manual, Transmig, Vaf4hd
Table of contents
Document Outline
- SECTION 1: GEneral Information
- SECTION 2: INTRODUCTION
- SECTION 3: INSTALLATION, Operation AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Mains Supply Voltage Requirements
- 3.05 Electromagnetic Compatibility
- 3.06 Front Panel Controls, Indicators and Features
- 3.07 Rear Panel Controls and Features
- 3.08 Advanced Features Mode
- 3.09 Wirefeeder Configuration for Different Power Sources
- 3.10 Attaching the Tweco No. 4 MIG Torch
- 3.11 Installing Handle Assembly
- 3.12 Installing Lifting Eye Kit (Optional)
- 3.13 Installing Tweco No. 5 Adaptor (Optional)
- 3.14 Installing Wire Spool Cover (optional)
- 3.15 Installing Welding Wire Spool
- 3.16 Wire Reel Brake
- 3.17 Inserting Wire into Feed Mechanism
- 3.18 Feed Roll Pressure Adjustment
- 3.19 Installing and Changing the Feed Roll / Removing Inlet Guide & Euro Adaptor
- 3.20 Shielding Gas Regulator Operating Instructions
- 3.21 Wire Feeder Set Up MIG (GMAW) Welding with Gas Shielded MIG Wire
- 3.22 Wire Feeder Set Up MIG (GMAW) Welding with Gasless MIG Wire
- 3.23 Prewelding Procedure
- 3.24 Arc Signal Override (SIL_1 #2)
- 3.25 Welding- 2T Operation
- 3.26 Spot Operation
- 3.27 Welding- 4T Operation
- 3.28 Stitch Operation
- 3.29 PTC Protection of Power Source Contactor Control Output
- 3.30 Ground Fault Operation
- 3.31 Electronic Motor Protection
- SECTION 4: service
- SECTION 5: Parts List
- Appendix 1: connection diagram
- CIGWELD LIMITED WARRANTY
- TERMS OF WARRANTY – January 2013
- WARRANTY SCHEDULE – January 2013
- GLOBAL CUSTOMER SERVICE CONTACT INFORMATION
- SECTION 1: ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
- CIGWELD LIMITED WARRANTY
- TERMS OF WARRANTY - APRIL 2010