Tweco 400i Transmig - Manual (Page 34)

TRANSMIG 400 i
4-12 July 18, 2008
4.13 Save-Load Operation
A total number of 5 programs can be saved into the Transmig 400 i memory.
SAVE the Current Weld Parameters into Memory
• Press and HOLD the SAVE button for 3 seconds. Beep will sound and Digital Meter display will show a
number 1.
• Select a memory location by rotating the control knob, 1 to 5 is displayed on the meter.
• After selecting the desired memory location (i.e. 1 to 5), press the right scroll button and the machine will
give a beep to confirm the weld parameters from the control panel are saved. The Save/Load buttons must
be depressed for 3 seconds to store settings.
LOAD (retrieve) a Program to Control Panel
• Press and HOLD the LOAD button for 3 seconds. Beep will sound and Digital Meter display will show a
number 1.
• Select a memory location by rotating the control knob, 1 to 5 is displayed on the meter.
• After selecting the desired memory location (i.e. 1 to 5), press the right scroll button and the machine will
give a beep to confirm the weld parameters are loaded onto the control panel. The Save/Load buttons
must be depressed for 3 seconds to store settings.