Tweco 400i Transmig - Manual (Page 17)

TRANSMIG 400 i
2-5 July 18, 2008
Parameter Transmig 400i
Power Source Part Number 710014
Cooling Fan Cooled
Welder Type Inverter Power Source
Welding Power Source Mass 25kg
Dimensions H 420mm x W 210mm x D 450mm
Manufactured to Australian Standard AS 60974.1-2006
Number of Phases 3
Nominal Supply Voltage 415V ±15%
Nominal Supply Frequency 50Hz
Open Circuit Voltage 65V
Welding Current Range 5 - 400 Amps
Effective Input Current (I1eff) 16.7 Amps
Maximum Input Current (I1max) 33.4 Amps
Three Phase Generator Requirement 24.0 KVA
Welding Output, 40
0
C, 10 min.
(quoted figures refer to MMAW
output)
400A @ 25%, 36.0V
300A @ 60%, 32.0V
200A @ 100%, 28.0V
Welding Output 40
0
C, 10 min.
(Quoted figures refer to GTAW
output)
400A @ 25%, 26.0V
300A @ 60%, 22.0V
200A @ 100%, 18.0V
Welding Output 40
0
C, 10 min.
(Quoted figures refer to GMAW
output)
400A @ 25%, 34.0V
300A @ 60%, 29.0V
200A @ 100%, 24.0V
Protection Class IP23S
Table 2-1: Specifications
Cigweld continuously strives to produce the best product possible and therefore reserves the right
to change, improve or revise the specifications or design of this or any product without prior
notice. Such updates or changes do not entitle the buyer of equipment previously sold or shipped
to the corresponding changes, updates, improvements or replacement of such items.
The values specified in the table above are optimal values, your values may differ. Individual
equipment may differ from the above specifications due to in part, but not exclusively, to any one
or more of the following; variations or changes in manufactured components, installation location
and conditions and local power grid supply conditions.
2.08 Specifications