Tweco 6045 Excel Arc - Manual (Page 30)

EXCEL ARC 6045 OPERATION
Manual 0-5213 4-4 August 26, 2011
ARC FORCE (STICK)
FORCE D'ARC
V
VOLTS
V / A
A AMPS
Professional
ON MARCHE ON MARCHE
OUTPUT ON
POWER PUISSANCE
ON MARCHE
WARNING: READ OPERATING MANUAL AVERTISSEMENT : LIRE LE MANUEL D’OPERATING
PROCESS
PROCESSUS
FCAW
CAG
ARC ON TIME (HRS)
ARC À L'HEURE
REMOTE COMMANDE À DISTANCE
REMOTE COMMANDE À DISTANCE
LOCAL
COMMANDE LOCALE
CONTROL COMMANDE HOT START
DE DÉPART CHAUD
OUTPUT CONTACTOR RENDEMENT CONJONCTEUR
OFF ARRÊT
OFF
ARRÊT
Ar
t# A-10892
1/4 turn both Front Cover Screws to release
Pull Down Front Panel Control Panel PCB
Hinge Pin
A
B
Figure 4-3: Front Panel Access
4.04 Hot Start Switch Enable/Disable
When activated, the HOT START SWITCH (Item “20.
HOT START SWITCH (SW3) – For STICK mode only
(SMAW/CAG)” on page 4-3) allows a short duration
pulse of higher current for ease of starting an arc in SMAW/
CAG mode only. The level and duration of the hot start
current are adjustable using two trim pots on the Control
Panel PCB.
1. Pull down the front panel. Refer to Section “4.03
Adjustments Behind the Control Panel” and “Figure
4-3: Front Panel Access”.
2. Locate the HOT START two trim pots on the Control
Panel PCB. R295 adjusts the hot start duration and
R275 adjusts the hot start current level. Refer to “Figure
4-4: Hot Start Level and Duration Adjustments”.
3. Using a small fl at-blade screwdriver, adjust the trim
pots in accordance with the parameters defi ned in
“Figure 4-4: Hot Start Level and Duration Adjustments”.