Section 2: introduction, 01 how to use this manual, 02 equipment identifi cation – Tweco 6045 Excel Arc User Manual
Page 15: 03 receipt of equipment, Introduction excel arc 6045

INTRODUCTION EXCEL
ARC
6045
August 26, 2011
2-1
Manual 0-5213
SECTION 2:
INTRODUCTION
2.02 Equipment
Identifi cation
The unit’s identifi cation number (specifi cation or part 
number), model, and serial number usually appear on a 
nameplate attached to the control panel. In some cases, the 
nameplate may be attached to the rear panel. Equipment 
which does not have a control panel such as gun and cable 
assemblies is identifi ed only by the specifi cation or part 
number printed on the shipping container. Record these 
numbers on the bottom of page i for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against the 
invoice to make sure it is complete and inspect the 
equipment for possible damage due to shipping. If there is 
any damage, notify the carrier immediately to fi le a claim. 
Furnish complete information concerning damage claims 
or shipping errors to the location in your area listed in the 
inside back cover of this manual.
Include all equipment identifi cation numbers as described 
above along with a full description of the parts in error.
Move the equipment to the installation site before 
un-crating the unit. Use care to avoid damaging the 
equipment when using bars, hammers, etc., to un-crate 
the unit.
2.01 How To Use This Manual
This manual applies to just specifi cation or part numbers 
listed on page i. 
To ensure safe operation, read the entire manual, including 
the chapter on safety instructions and warnings.
Throughout this manual, the words WARNING, 
CAUTION, and NOTE may appear. Pay particular attention 
to the information provided under these headings. These 
special annotations are easily recognized as follows:
!
WARNING
A WARNING gives information regarding 
possible personal injury. 
CAUTION
A CAUTION refers to possible equipment 
damage.
NOTE
A NOTE offers helpful information concerning 
certain operating procedures. 
Additional copies of this manual may be purchased 
by contacting Thermal Arc at the address and phone 
number for your location listed in the inside back cover 
of this manual. Include the Owner’s Manual number and 
equipment identifi cation numbers.
Electronic copies of this manual can also be downloaded at 
no charge in Acrobat PDF format by going to the Thermal 
Arc web site listed below and clicking on the Literature 
Library link:
www.thermadyne.com/thermalarc
