Tweco 201 ts Thermal Arc User Manual
201 ts operating manual, Thermal arc, Inverter arc welder
Table of contents
Document Outline
- SECTION 1:ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2:INTRODUCTION
- SECTION 3:INSTALLATION, OPERATION AND SETUP
- SECTION 4:OPERATION
- 4.01 Front Panel
- 4.02 Welding Current Control Explanation
- 4.03 STICK (MMA) Electrode Polarity
- 4.04 Effects of Stick Welding Various Materials
- 4.05 GTAW Electrode Polarity
- 4.06 Guide for Selecting Filler Wire
- 4.07 Tungsten Electrode Current Ranges
- 4.08 Shielding Gas Selection
- 4.09 Tungsten Electrode Types
- 4.10 TIG Welding Parameters for Steel
- 4.11 Arc Welding Practice
- 4.12 Welding Position
- 4.13 Joint Preparations
- 4.14 Arc Welding Technique
- 4.15 The Welder
- 4.16 Striking the Arc
- 4.17 Arc Length
- 4.18 Rate of Travel
- 4.19 Making Welded Joints
- 4.20 Distortion
- 4.21 The Cause of Distortion
- 4.22 Overcoming Distortion Effects
- SECTION 5:SERVICE
- APPENDIX 1: OPTIONS AND ACCESSORIES
- APPENDIX 2: REPLACEMENT PARTS
- APPENDIX 3: 201 TS SYSTEM SCHEMATIC
- LIMITED WARRANTY & WARRANTY SCHEDULE
- SECTION 1: ARC WELDING SAFETY INSTRUCTIONS AND WARNINGS