Tweco 100 XT Ultra-Cut Plasma Cutting System - Manual (Page 83)

ULTRA-CUT 100 XT
Manual 0-5272 OPERATION 4-19
CCM Status Code
Code Message Remedy / Comments
Group 6 -- CCM
601 Analog Voltage Error Defective CCM, replace.
602 ADC or DAC error Defective CCM, replace.
603 Reserved No information available; Contact customer service
604 Data Memory error Defective CCM, replace.
605 Program memory fault Defective CCM, replace.
606 +5V Logic supply low Defective CCM, replace.
607 Processor over temperature Reduce ambient temperature; Defective CCM; replace
608
5V supply for RS 485/422 com-
munication low.
Defective CCM, replace.
609 Firmware Update Device Error Defective CCM; replace
610 Firmware Update Protocol Error Defective CCM; replace
611 USB Controller Fault Defective CCM; replace
612 USB Power Fault Faulty USB device plugged into USB port, remove; Defective CCM
613
USB Log Creation Fault
Unable to create Log file on USB Flash drive last firmware update at-
tempt; Use different USB Flash Drive or Reformat
614
No USF File
File VTCCMFW.USF missing from Flash Drive; Add proper files to Flash
Drive for Firmware Update; Use different USB Flash Drive or Reformat
615
No CCM Update File
CCM Firmware file specified in VTCCMFW.USF not found ; Add proper
files to Flash Drive for Firmware updating
616
DPC Update Fault
Fault occurred attempting to update DPC firmware; Add proper files to
USB Flash drive for Firmware updating; Refer to CCM_LOG.TXT on Flash
Drive for details
617
DMC Update Fault
Fault occurred attempting to update DMC firmware; Add proper files to
USB Flash drive for Firmware updating; Refer to CCM_LOG.TXT on Flash
Drive for details
618 ADC Calibration Fault Error too large calibrating ADC; Fault persists defective CCM;
619 Flow Switch Fault Flow switch reporting coolant flow when pump off;
620
Non Volatile Memory Error
Non Volatile Memory Storage Corrupted and Erased; Fault persists
defective CCM.