Tweco 150 Ultra-Cut - Manual (Page 42)

Manual No. 0-4800 3-20 INSTALLATION
B. Connect Fiber Optic Cable (Type 2 internal control module)
CAUTION
Check the type of internal control module. Use this section for connections to an internal control module without
an external connections cover. Use the preceding section for connections to an internal module with an external
connections cover.
1. Connect one end of each cable to the power supply as shown.
a. Remove the strain relief securing nut from the strain relief on the fiber optic cable(s). Loosen the strain
relief dome nut from the strain relief.
b. Pass the cable connector through the appropriate opening. Slide the strain relief securing nut onto the
cable. Make a loop of the cable; carefully press the cable connector into the appropriate receptacle on the
internal control module.
c. Tighten the strain relief onto the cable(s). Do not overtighen.
To Gas Control Module
To Remote HMI
(if installed)
Profile Detail, Fiber Optic Cable Installation
Cable Receptacles
To Slave Power
Supply
(if installed)
Art # A-06793