Tweco SC10 - Manual (Page 25)

Manual 0-2479 3-9 INSTALLATION PROCEDURES
A-00690
MOTOR
J43
Lifter Motor
Control Cable
Figure 3-17 Cable Connections
3.11 Lifter Motor Installation
A. Mounting Holes
NOTE
Refer to the exploded view of the Lifter Motor As-
sembly for parts location and assembly.
The Lifter Motor Assembly must be mounted to the Cut-
ting Table. Mount the assembly per the following proce-
dure:
1. Lossen the four screws securing the Front Cover
to the assembly.
2. Remove the Front Cover from the assembly.
3. Use the template at the end of this Manual to lo-
cate the four mounting holes noting the follow-
ing:
• The bottom edge of the Lifter Motor Assem-
bly must be able to clear and obstructions in
the cutting path.
• The assembly must be mounted low enough
to allow proper operation of the Torch Assem-
bly.
4. Drill and tap four holes for 1/4-20 bolts.
5. Mount the Lifter Motor Assembly to the four
tapped holes using the four bolts and washers
supplied.
6. Reinstall the Front Cover and tighten the four
cover screws.
B. Torch Assembly Installation
1. Place the end of the Rack and Pinion Assembly
into the Torch Holder Pivot.
2. Tighten the wing nut and washer to secure the
Rack and Pinion Assembly to the Lifter Motor As-
sembly.
3. Route the Torch Leads up and over the Hose
Holder.
4. Connect the end of the Torch Leads per the ap-
propriate Torch Manual.