Tweco PCM-62 Machine Torch User Manual
Plasma cutting torch
This manual is related to the following products:
Table of contents
Document Outline
- SECTION 1: GENERAL INFORMATION
- 1.01 Notes, Cautions and Warnings
- 1.02 Important Safety Precautions
- 1.03 Publications
- 1.07 Declaration of Conformity
- SECTION 2: INTRODUCTION
- 2.01 Scope of Manual
- 2.02 General Description
- 2.03 Specifications & Design Features
- 2.04 Options And Accessories
- 2.05 Introduction to Plasma
- SECTION 3: INSTALLATION
- 3.01 Introduction
- 3.02 Site Location
- 3.03 Unpacking
- 3.04 Setting Up Hand Torch
- 3.05 Setting Up Machine Torch
- 3.06 Connecting Torch
- 3.07 Gas Connection
- SECTION 4: OPERATION
- 4.01 Introduction
- 4.02 Functional Overview
- 4.03 Getting Started
- 4.04 Torch Parts Selection
- 4.05 Cut Quality
- 4.06 General Cutting Information
- 4.07 Hand Torch Operation
- 4.08 Machine Torch Operation
- 4.09 Recommended Cutting Speeds
- 4.10 Gouging
- SECTION 5: SERVICE
- 5.01 Introduction
- 5.02 General Torch Maintenance
- 5.03 Common Operating Faults
- 5.04 Inspection and Replacement Consumable Torch Parts
- 5.05 Troubleshooting Guide
- 5.06 Torch & Leads Troubleshooting
- 5.07 Servicing Hand Torch (PCH) Components
- 5.08 Servicing Machine Torch (PCM) Components
- SECTION 6: PARTS LISTS
- 6.01 Introduction
- 6.02 Ordering Information
- 6.03 Replacement Hand Torch Parts (Ergonomic Handle)
- 6.04 Replacement Machine Torch Parts
- 6.05 Replacement Torch Lead Parts
- 6.06 Complete Torch & Leads Assembly Replacement
- 6.07 Options and Accessories
- 6.08 Torch Spare Parts Kits
- APPENDIX 1: TYPICAL SYSTEM SEQUENCE OF OPERATION BLOCK DIAGRAMS
- For CutMaster 50 Applications
- For PakMaster 50XL Plus Applications
- APPENDIX 3: GENERAL APPLICATION NOTES
- APPENDIX 4: CUTMASTER 50 APPLICATION
- APPENDIX 5: PAKMASTER 50XL PLUS APPLICATION
- APPENDIX 6: CE PAKMASTER 50XL PLUS APPLICATION
- APPENDIX 7: HAND TORCH CONNECTION